娛樂滿紛 26FUN - Powered by Discuz! Board

標題: Create a bootable Windows Vista on USB stick Flash Memory [打印本頁]

作者: admin 時間: 2008-8-29 08:00 AM 標題: Create a bootable Windows Vista on USB stick Flash Memory

The following step assume
flash drive = disk x = e:
dvd drive = d:

1. Format the USB flash memory drive to FAT32 file system

Run CMDfilter-031 and type the following command. Note: This set of commands assumes that the USB flash drive is addressed as “disk x″. Double check that by doing a list of the disks (type “list disk”) before cleaning it).

diskpart
select disk x
clean
create partition primary
select partition 1
active
format fs=fat32
assign
exit

2. Copy Windows Vista’s DVD ROM content to the Flash DriveType
in command to start copying all the content from the Windows Vista DVD to your newly formatted high speed flash drive.

xcopy d:\*.* /s/e/f e:\

3. make the usb stick bootable
Open a DOS prompt, find BOOTSECTfilter-031, and in the command window, type:

Bootsector /nt60 e:

歡迎光臨娛樂滿紛 26FUN (http://26fun.com/bbs7/)